Nortel Networks 8003AC, 8005DC, 8004AC, 8004DC, 8005AC manual Navigation, Removing a module

76Installing Metro Ethernet Routing Switch 8600 modules and connecting equipment

•Handle fiber-optic equipment with the following precaution.

WARNING

Fiber-optic equipment can emit laser or infrared light that can injure your eyes. Never look into an optical fiber or connector port. Always assume that fiber-optic cables are connected to a light source.

Navigation

•"Removing a module" (page 76)

•"Installing a module" (page 81)

Removing a module

Remove or replace a module in your chassis.

You can remove any Metro Ethernet Routing Switch 8600 module from an operating switch chassis without turning off the chassis power.

Prerequisites

•Back up your configuration before you remove a 8691omSF or 8692omSF module.

CAUTION

If the chassis has only one 8691omSF or 8692omSF module and you remove that module, the switch will not operate.

•After you remove or replace a module in your chassis, you can expect the following results:

—If you remove an interface module from an operating switch without turning off the chassis power and replace it with the same type module, the system restores the configuration.

Nortel Metro Ethernet Routing Switch 8600

Installation — Modules

NN46220-306 02.02 Standard

4.27 July 2008

Copyright © 2005-2007, Nortel Networks