Installation (for qualified installers only) | 25 |
Diffuser Plate Adjustment
Certain vent configurations require the diffuser plate to be adjusted (refer to the approved vent configuration charts for details). Position # 1 is stock (bent). Position # 2 is flattened. See the directions below to change the diffuser to position #2.
Firebox Roof
Back Wall of Firebox
DIFFUSER SIDE VIEW
Before (Stock - Position # 1)
After (Position # 2)
Remove the exhaust restrictor.
1/4" Nutdriver
1/4" Nutdriver
Remove the diffuser.
Bend the round portion of the diffuser so it is flat (position # 2)
Secure the flattened diffuser plate with the screws removed earlier.
Replace the exhaust restrictor (see “Exhaust Restrictor Adjustment” for restrictor settings).
© Travis Industries | 4070201 |
