Oki 390, 391 manual Changing Paper Paths, Continuous-forms to single-sheet feed

Changing Paper Paths

Continuous-forms to single-sheet feed

1Tear off any printed pages.

2Press PARK.

3Raise the paper separator to the single-sheet feed position.

4Place the wire feed guide in the paper separator.

5Move the paper lever to the position marked “TOP.” The paper lever is towards the back of the printer.

6Place a sheet of paper in the paper separator.

Single-sheet feed to continuous forms

1Press FF/LOAD to remove the single-sheet paper.

2Lower the paper separator into the continuous-forms position. Swing the wire feed guide over onto the pull-up roller.

3Move the paper lever to the appropriate position.

For rear feed (1), the paper lever is towards the front of the printer.

For bottom feed, (2), the paper lever is in the center position.

4If necessary, load continuous-form paper.

5Press FF/LOAD.

1

2

54 Microline 390/391 Turbo