POSTSCRIPT ERROR OCCURS IF A BANNER PAGE IS PRINTED
A PostScript banner page cannot be printed in NetWare 3.12 Remote Printer mode. If a PostScript printer is used and a banner page is printed, PostScript error is displayed. Turn the banner output Off in the client’s printer settings.
ETHERTALK
NOT IDENTIFIED BY THE CHOOSER AND THE SETUP UTILITY
Turn the printer off for 15 seconds and then on again. Check the network cable is correctly connected. Change the cable and try again.
If the network resides in a zone, check the correct zone name is selected in the Chooser.
Check the zone name in the utility related to the NIC is the same as the zone name set in NIC.
Check AppleTalk, which is displayed at the right bottom of the Chooser, is set to Enable. (In some OS versions Network is used instead of AppleTalk.)
Check Ethernet is selected in AppleTalk. (In some OS versions Network is used instead of AppleTalk.)
Check the printer driver is selected in the Chooser. Check the EtherTalk protocol is set to Enable.
Print the NIC settings and confirm that the EtherTalk port name is not blank.
NETBEUI
The network interface card is not identified.
Turn the printer off for 15 seconds and then on again. Check the network cable is correctly connected. Change the cable and try again.
Check Microsoft Network Client and NetBEUI have been added to the network section of the Windows Control Panel.
Troubleshooting> 90
