SETUP UTILITIES FOR MAC OS 8.X AND 9.X
Use the Network Card Setup Utility (Macintosh) to assign an IP address and configure the network interface card. For instructions please refer to the Configuration Utility section and
CONFIGURATION
There are three items that need to be configured for EtherTalk. Use EtherTalk Protocol
Please check the Use EtherTalk Protocol checkbox.
1.Printer Name
2.Give the Printer Name as you would like it to appear in the Chooser.
3.Zone Name
If your network uses Zones, please enter the Zone Name here, otherwise leave as is.
APPLETALK CONFIGURATION
To enable network printing from the Macintosh, you must configure AppleTalk to connect via Ethernet.
1.From the Apple menu select [Control Panels – AppleTalk].
2.From the AppleTalk configuration page select [Connect via: Ethernet].
3.In Setup Current Zone, if used, make sure that your zone information is correct.
4.Close the AppleTalk configuration page and save changes to current configuration when prompted.
5.Configuration is now complete and you are ready to install your printer driver. Please enter your driver CD, run the installer and follow the
Apple Macintosh> 85
