4.2 Setting a New IP Address over the Network
Besides using the iConnect software, you may use the iSE’s default IP address to access it and assign a new IP address to it.
The iSE is shipped with a default IP address of 192.168.1.200 and Subnet Mask of 255.255.255.0. You can configure your PC’s Network connection with an IP address that is in the same range as the iSE’s IP address (192.168.1.x) and connect to the iSE using a crossover network cable between your PC and the iSE.
With this completed, you can go to the
Select Access Control , button, you’ll be asked for the password. The default LOGIN password is "12345678" and the ADMINISTRATOR password is "00000000", then you should be on the Access Control page were you can simply type in the desired Static IP address, and click Save.
ACCESS CONTROL
Address http://192.168.1.200
ACCESS CONTROL
Login Password: | 12345678 | ||
Admin Password: | 00000000 | ||
Host Name: | eis21d9 | ||
MAC Address: 00:03:03:00:21:D9 | |||
IP Address: 192.168.1.200 | |||
Gateway Address: |
| 0.0.0.0 | |
Subnet Mask: | 255.255.255.0 | ||
Camera IP: 0.0.0.0 | Camera Location | ||
Camera Label: |
| ||
Click the following button to activate the new settings. | |||
Save | Reset | ||
Power Recycle
Main Menu
Figure 4.4 Access Control
For the IP address to take effect, the iSE needs to be turned OFF/ON. Clicking the “Power Recycle” button will turn the iSE OFF and ON. Pressing the physical button marked “RESET” on the iSE does the same thing.
You can now connect the iSE to an Ethernet hub using a straight through cable, power it up, and follow the ping routine mentioned in the previous section.
18
