When the mode is set to ELC, the electronic shutter may not function if the iris is set to AUTO in the SETUP menu and the lens iris switch to M (manual). Make sure that the camera and lens settings are the same. If ELC is selected, flicker may increase under fluores- cent lights.

4White Balance Setting [WHITE BAL: ATW, A CH, B CH, MANU, P SET 3.2K, P SET 5.6K]

When the mode is set to ATW, white balance is auto- matically adjusted at all times.

When the mode is set to A CH or B CH, with SETUP menu OFF, white balance is automatically adjusted with the AWC switch on the back of the camera. Color temperature conditions of two scenes can be stored in the A CH/B CH memories. When the painting mode is ON, fine color adjustment can be made by red/blue gain setting of INITIAL SET menu after AWC.

When the mode is set to MANU, white balance can be adjusted by red/blue gain setting of INITIAL SET menu.

When the mode is set to P SET 3.2K, white balance is adjusted to 3200K illumination.

When the mode is set to P SET 5.6K, white balance is adjusted to 5600K illumination.

Note:

When the camera is used with an RCU (RCB), the switch cannot be set to MANU, P SET 3.2K, or P SET 5.6K.

5Detail Level Setting [DTL LEVEL: OFF, LOW, HIGH] Use this mode to select any of three detail levels as desired: HIGH, LOW, OFF.

*Low or high level ranges can be set by using a USER SET menu.

6Scene File Selection Setting [SCENE FILE: 1, 2, 3,

USER A, USER B] Mode 1:

USER A/B -- User set SCENE 1:

SCENE 2: SCENE 3:

Mode 2:

USER A/B -- User set SCENE 1:

SCENE 2: SCENE 3:

Mode 3:

USER A/B -- User set SCENE 1:

SCENE 2: SCENE 3:

Mode 4:

USER A/B -- User set SCENE 1:

SCENE 2: SCENE 3:

*USER A and B have a memory for each operation mode (8 in total).

-35-

Page 37
Image 37
Panasonic AW-E560 manual Scene 2 Scene