Panasonic DF-1100 manual 41

Customizing Your Machine

No.	Parameter	Setting	Setting				Comments
		Number
12	COMM. JOURNAL	1	Off	Selecting the home position of printout mode for COMM.
				Journal Off/Always/INC.						3
		2	Always
				Off	: No printout
				Always : Always prints out
		*3	Inc. only
				Inc. only : Printout when communication					has failed.
13	AUTO JOURNAL PRINT	1	Invalid	Selecting whether the machine prints the journal
				automatically after every				32 transactions.
		*2	Valid
14	FILE ACCEPTANCE	*1	Invalid	Selecting whether the machine prints the file acceptance
	REPORT			journal. If		you	set this parameter to valid, the journal will
				be	printed	out	after entering any communications using
		2	Valid
				memory.
17	RECEIVE MODE	1	Manual	Setting the reception mode to either automatic or manual.
		*2	Auto
22	SUBSTITUTE RCV	1	Invalid	Selecting whether the machine receives to memory when
				recording paper runs out, toner runs out or recording paper
		*2	Valid	is jammed.
24	PRINT REDUCTION	1	Fixed	Selecting print reduction mode.
				Fixed:Reduce received document according to the setting
					of Parameter No. 25.
		*2	Auto	Auto: Reduce received document according to the length of
					received documents.
25	REDUCTION RATIO	70	70%	Selecting fixed print reduction ratio from 70% to 100%. This
				parameter functions only when fixed print reduction is
				selected on Fax Parameter No. 24.
		100	100%
26	POLLING PASSWORD		(----)	Setting a 4-digit password for secured polling.
27	POLLED FILE SAVE	*1	Invalid	Selecting whether the machine retains the polled
				document in memory even after the document is polled
		2	Valid	once.
28	STAMP AT MEM. XMT	1	Invalid	Selecting whether the machine stamps the original
				documents when storing the documents into memory.
		*2	Valid	(dependant on the Stamp setting on the Control Panel.)
31	INCOMPLETE FILE	*1	Invalid	Selecting whether the machine retains the document in
	SAVE			memory if the document				is not successfully transmitted.
		2	Valid
34	POWER SAVE TIMER	--	Start-Time	To	reduce	the	power	consumption	of the machine in
				standby, select the time period to turn off the high
				temperature fuser unit when the printer is idle.
		--	End-Time	Factory default			is always ºONº (When		Start = 00:00 and
				End = 00:00).

Continued on the next page.

39