Basic Transmission Settings

You can temporarily change the following transmission settings either before or after you place the document on the ADF or Platen Glass.

•Contrast

•Resolution

•Stamp

•Communication Journal

After your document has been sent, your machine will automatically return to the preset settings.

Contrast

Your machine is preset to Normal contrast. If you wish to send a document with lighter contrast, change the setting to Lighter or Lightest. If you wish to send a document with darker contrast, change the setting to Darker or Darkest.

Press CONTRAST to:

CONTRASTCONTRASTCONTRASTCONTRASTCONTRAST CONTRAST

 

 

 

 

 

 

OR

 

 

 

 

 

A

"

A

"

A

"

A

"

A

"

A

"

CONTRAST

CONTRAST

CONTRAST

CONTRAST

CONTRAST

CONTRAST

= Normal

= Darker

 

= Darkest

= Normal

= Lighter

= Lightest

Note: To change the preset Contrast position, change the setting of Fax Parameter No. 01 (see page 38).

Resolution

Your machine is preset to Standard resolution, which is suitable for most documents.

Use Fine or Super Fine for detailed documents or Photo for photographs or illustrations with gray tones.

Press RESOLUTION to:

RESOLUTION

RESOLUTION

RESOLUTION

RESOLUTION

FINE S-FINE PHOTO

FINE S-FINE PHOTO

FINE S-FINE PHOTO

FINE S-FINE PHOTO

RESOLUTION = Standard

RESOLUTION = Fine RESOLUTION = Super Fine

RESOLUTION = Photo

Note: To change the preset Resolution position, change the setting of Fax Parameter No. 02 (see page 38).

Verification Stamp

The Verification Stamp helps you to confirm successful transmissions by stamping the bottom of each successfully transmitted page with a small  mark.

Press STAMP to:

STAMPSTAMP

STAMP = Off

STAMP = On

Note: 1. When you store a document in memory, the Verification Stamp will stamp on the document if it is successfully stored in memory. In this case the Verification Stamp is not a confirmation that the document was successfully transmitted. If you wish to disable the use of the Verification Stamp when storing a document in memory, change the setting of Fax Parameter No. 28 (see page 39).

2.To change the preset Verification Stamp position, change the setting of Fax Parameter No. 04 (see page 38).

46