Panasonic K10059 manual Bypassing Protection Zones Quick Bypass

SecurityPhone.book 16 ページ ２００４年７月２１日 水曜日 午後６時５８分

Bypassing Protection Zones

Quick Bypass

If the Quick Bypass is programmed by the security system installer, you can set all faulted (open) zones unprotected at once. Confirm with your installer if the Quick Bypass is active for your system.

When Quick Bypass is used, all faulted (open) zones are unprotected, the alarm does not sound, and an alarm signal is not sent to the Customer Monitoring Center. Refer to “Quick Bypass” on page 21 in the 3000EN Security Systems User’s Guide.

Make sure all perimeter doors and windows are closed and READY is displayed.

Base Unit

1Press [ADT].

2	Scroll to “BYPASS” by pressing [d] or [B], then
		gBYPASS
	press [g].
3	Scroll to “QUICK BYPASS” by pressing [d] or
		gQUICK BYPASS
	[B], then press [g].
4	Enter your security code.
		ENTER CODE
	• If you entered the wrong security code, the phone	----

will go back to the previous display. Try again from step 3.

• In a few seconds, all faulted (open) zones are displayed and automatically bypassed.

• The “Bypass” message is displayed momentarily.

5Press [STOP] to go to the standby mode.

Handset : Press the soft key ( ADT ), and follow steps 2 to 4 above, using the cordless handset. Press [OFF] to go to the standby mode.

16