SecurityPhone.book 10 ページ 2004年7月21日 水曜日 午後6時58分

Arming the System

Setting the Night-Stay mode

When you want to get more increased security than the Stay mode, select this mode.

When you set the Night-Stay mode,

the perimeter zones and pre-selected interior sensors (programmed by your installer) are armed, and

if the protected perimeter windows and doors are opened or interior zones are violated, an alarm sounds immediately.

Base Unit

1Press [ADT].

2

Press [g] at “ARM”.

 

 

 

 

gARM

 

 

 

 

 

 

 

 

 

 

3

Scroll to Night-Stay by pressing [d] or

 

 

 

 

gNight-Stay

 

 

[B], then press [g].

 

 

 

 

 

 

 

4

Enter your security code.

 

 

 

 

ENTER CODE

 

 

• If you entered the wrong security code, the phone

 

----

 

 

will go back to the previous display. Try again from

 

Example

 

step 2.

 

;;;NIGHT-STAY;;;

 

 

• The armed NIGHT-STAY message is displayed.

 

You may exit now

 

 

 

 

 

 

5Press [STOP] to go to the standby mode.

Handset : Press the soft key ( ADT ), and follow steps 2 to 4 above, using the cordless handset. Press [OFF] to go to the standby mode.

• To exit the menu, press [STOP] or [OFF].

To confirm the security mode you set, press [ADT] in the standby mode.

IMPORTANT:

When the Night-Stay mode is on, the selected interior zones are armed and cause an alarm if anyone enters those areas (e.g., waking in the middle of the night). To avoid sounding an alarm, you must disarm the system before any activity takes place in those interior zones

10

Page 10
Image 10
Panasonic K10059 manual Arming the System Setting the Night-Stay mode, Scroll to Night-Stay by pressing d or