SecurityPhone.book 24 ページ 2004年7月21日 水曜日 午後6時58分

Device Commands

If some devices are set up for your system, you can activate or deactivate certain lights or other devices using the Device Commands menu.

Confirm with your installer for devices set up for your system.

Refer to “Using Device Commands” on page 27 in the 3000EN Security Systems User’s Guide.

To activate/deactivate devices

Base Unit

1Press [ADT].

2

Scroll to “OTHER FUNCTIONS” by pressing [d]

 

 

 

 

 

 

 

 

gOTHER FUNCTIONS

 

 

or [B], then press [g].

 

 

 

 

 

 

 

 

 

 

 

3

Scroll to “DEVICE COMMANDS” by pressing [d]

 

 

 

 

 

 

 

 

gDEVICE COMMANDS

 

 

or [B], then press [g].

 

 

 

 

 

 

 

 

 

 

 

4

To activate devices, press [g] at “ACTIVATE

 

 

 

 

 

 

 

 

gACTIVATE DEVICE

 

 

DEVICE”.

 

 

 

To deactivate devices, scroll to “DEACTIV.

 

 

 

OR

 

 

 

DEVICE” by pressing [d] or [B], then press

 

g

DEACTIV. DEVICE

 

 

[g].

 

 

 

 

 

 

 

 

 

 

 

 

5

Enter your security code.

 

 

 

 

 

 

 

 

ENTER CODE

 

 

 

 

 

 

 

 

----

 

 

 

 

 

 

 

 

 

 

6

Enter the desired device number.

 

 

 

 

 

 

 

 

ENTER DEVICE #

 

 

(Ex. To select device number 5, enter “05”.)

 

 

 

 

 

--

 

 

 

 

Example

 

 

 

 

 

ENTER DEVICE #

 

 

 

 

 

 

 

 

05

 

 

 

 

 

 

READY

 

=ENTER

 

 

 

 

 

 

 

 

g

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7Press [g] (ENTER).

If a confirmation tone (one beep) is not heard, you entered the wrong security code in step 5 or wrong device number in step 6. The setting is not saved. Try again from step 4.

8Press [STOP] to go to the standby mode

Handset : Press the soft key ( ADT ), and follow steps 2 to 6 above, using the cordless handset. Press the soft key ( OK ), then press [OFF] to go to the standby mode.

24

Page 24
Image 24
Panasonic K10059 manual Device Commands, GDEVICE Commands, GACTIVATE Device