SecurityPhone.book 48 ページ 2004年7月21日 水曜日 午後6時58分

Troubleshooting

If the handset display shows error messages, see “If the Following Appear on Your Display...” (p. 47) for the Cause & Remedy.

Problem

Cause & Remedy

You cannot enter the function menu by pressing [ADT].

[ADT] may have been pressed while the phone is in use. When the phone is not in use, try again.

The phone does not sound alarm, when the system is armed.

Check the settings.

The handset may not sound alarm when the handset has lost communication with the base unit.

The phone does not sound

• Mute security mode is set to “Mute all

chime, when chime mode is

sounds”. Turn the setting to “sound all”

set to on.

(p. 43).

 

 

No dial tone present.

• When the security system is in

 

communication with the Customer Monitoring

 

Center (ex. periodic test reports, during alarm

 

reports), there is no dial tone. You cannot

 

make phone calls until dial tone is restored.

Regulatory Statements and Warnings

NOTE: This is a “Grade A” Residential System

RADIO FREQUENCY EMISSIONS

Federal Communications Commission (FCC) Part 15

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Industry Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet Appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

48

Page 48
Image 48
Panasonic K10059 manual Troubleshooting, Regulatory Statements and Warnings, Federal Communications Commission FCC Part