18
Setting the Date and Time
You can set the date and time of the security system by following the operation
below. The date and time setting for the telephone should be programmed through
the “Telephone” menu.
While the security system is armed, you can not set the Date and Time. To
set, disarm the security system (p. 12).
: Press the soft key ( ), and follow steps 2 to 7 above, using
the cordless handset. Press [OFF] to go to the standby mode.
1Press [ADT].
2Scroll to “OTHER FUNCTIONS” by pressing [
d
]
or [
B
], then press [
g
].
3Scroll to “DATE/TIME” by pressing [
d
] or [
B
],
then press [
g
].
4Enter your security code.
• The current date and time are displayed.
• If you entered the wrong security code, the phone
will go back to the previous display. Try again from
step 2.
5Press [*].
• To exit the menu, press [0] to [9] or [#], or wait for
30 seconds. Then press [OFF]
61Enter 4 digits for the time (hour and
minute). (Ex. To set 9:30, enter “0930”.)
2When the cursor is on “A” or “P”, press [1]
for PM or [0] for AM.
3Enter 2 digits each for the year, month, and
day. (Ex. To set May 15, 2004, enter “04 05
15”.)
• Military time can not be used.
• To move the cursor to the right, press [*].
To move the cursor to the left, press [#].
• If you entered the wrong number, the cursor do not
move to the next item.
• To cancel the setting, press [#] at the first digit or
wait for 30 seconds.
7To save the new setting, press [*] at the last digit.
8Press [STOP] to go to the standby mode.
Base Unit
OTHER FUNCTIONS
g
DATE/TIME
g
ENTER CODE
----
Time/Date SAT
12:00AM 01/01/00
Time/Date SAT
09:30A2004/05/15
Example
Handset
ADT
SecurityPhone.book 18 ページ ２００４年７月２１日　水曜日　午後６時５８分