GigaX Series L3 Managed Switch User Guide

password (old password, no password by default): <new password>

[Reboot]

User can reboot the switch by issuing the reboot command.

CLI command: sys reboot

[Upload]

No CLI command for this function. Refer to Boot ROM commands for this function.

5.3.2Physical Interface Commands

[Admin] [Enable/Disable]

Displays the port admin status, allow user to turn the port on or off.

CLI command : l2 port admin <port number> <enable/disable>

[Mode] [Auto/10M-Half/10M-Full/100M-Half/100M-Full/1G-Full]

Displays the current speed and duplex mode of the port. The speed and duplex mode can be automatically detected when auto-negotiation is enabled on a port.

CLI command : l2 port autoneg <port number> <enable/disable>

CLI command : l2 port speed <port number> <10/100/1000>

CLI command : l2 port duplex <port number> <full/half>

[Flow Control] [Enable/Disable]

Displays the IEEE802.3x flow control setting of a port. Note that this flow control is operating only in full duplex mode.

CLI command : l2 port flow <port number> <enable/disable>

[Reload]

Restores the previous port settings from the configuration file.

85

Page 85
Image 85
Asus GigaX manual Physical Interface Commands, Reboot, Upload, Flow Control Enable/Disable, Reload