
Problem |
|
| Suggested Action | |
|
| |||
Web Configuration Interface |
| |||
You forgot/lost your | 1. | If you have not changed the password from the default, try using | ||
WEB Configuration |
| “admin” as the user ID and bypassing password. | ||
Interface user ID or | 2. | Login to console mode through RS232 or USB, use “sys user | ||
password. | ||||
| show” to display the lost information | |||
|
| |||
|
|
| ||
Some pages do not | 1. | Verify that you are using Internet Explorer v5.5 or later. | ||
display completely |
| Netscape is not supported. Support for Javascript® must be | ||
|
| enabled in your browser. Support for Java® may also be | ||
|
| required. |
| |
| 2. | Ping the switch IP address to see if the link is stable. If some | ||
|
| ping packets fail, check your network setup to make sure a valid | ||
|
| setting. |
| |
Changes to | Be sure to click on | button in the Save Configuration | ||
Configuration are | ||||
page to save any changes. | ||||
not being retained. | ||||
|
|
| ||
|
|
|
| |
Console Interface |
|
|
| |
Cannot show the | 1. | The factory default baud rate is 9600, no flow control, 8 bit data, | ||
texts on the terminal |
| no parity check and stop bit is one. | ||
emulator. | 2. | Change your terminal emulator setup to this number. If you are | ||
| ||||
|
| using USB to connect the switch, install the USB driver first. | ||
| 3. | Check if the cable is good. | ||
|
|
|
|