[RIP-disabled interfaces]

You can specify an L3 interface as RIP-disabled interface if you do not want this interface to deal with any RIP message, either incoming or outgoing.

CLI command : l3 rip interface remove <interface name/* for all>

5.3.4Bridge Commands

[Spanning Tree is] [STP Enabled/ RSTP Enabled/ Disabled]

Allows user to specify whether the switch participates in the Spanning Tree Protocol (STP/ RSTP).

CLI command : l2 stp start <stp / rstp>

CLI command : l2 stp stop

[Hello Time]

[Forward Delay]

[Max Age]

[Bridge Priority]

Displays the current STP/RSTP bridge parameters setting.

CLI command : l2 stp bridge set

Hello Time (1..10 seconds):[old Hello Time] <new Hello Time>

Max Age (6..40 seconds):[ old Max Age] <new Max Age>

Forward Delay (4..30 seconds):[ old Forward Delay] <new Forward Delay>

Bridge Priority (0..61440):[ old Bridge Priority] <new Bridge Priority>

[Priority] [Path Cost] [Edge Port] [Point-to-point]

Displays the current STP/RSTP ports parameters setting.

CLI command : l2 stp port set

Port Settings (all,…):[all] <select a port number, or just type ‘all’ to iteratively config>

Port <port number> Priority (0..240):[old port Priority] <new port Priority>

88

Page 88
Image 88
Asus GigaX manual Bridge Commands, RIP-disabled interfaces