7. Programmable Features
1.Press {MENU}.
2.Press {#}, then {4}{1}.
3.Press {A} or {B} repeatedly to select “ON”.
4.Press {SET}.
5.Enter your code from 2 to 4 digits, using
{*} and {#}.
L The default code is “;#9”. L Do not enter “0000”.
6.Press {SET}.
7.Press {MENU}.
Code #44: Setting the memory reception alert
RECEIVE ALERT
MODE=ON [±]
To alert you with a beeping sound when a received fax document is stored into memory due to some existing problem.
The slow beeps will continue until you clear the printing problem and make sure the unit is supplied with enough paper to print the stored document.
“ON” (default): You will be alerted to a reception problem by a beeping sound.
“OFF”: Deactivates this feature.
Code #46: Setting friendly reception
FRIENDLY RCV
MODE=ON [±]
To receive a fax automatically when you answer a call and hear a fax calling tone (slow beep). “ON” (default): You do not have to press {FAX START} for fax reception.
“OFF”: You have to press {FAX START} for fax reception.
Code #68: Setting the Error Correction Mode (ECM)
ECM SELECTION
MODE=ON [±]
This feature is available when the transmitting/receiving fax machines are ECM compatible.
“ON” (default): To send a fax even if there is static interference on the telephone line. “OFF”: Deactivates this feature.
Code #76: Setting the connecting tone
CONNECTING TONE
MODE=ON [±]
If you often have trouble when sending faxes, this feature allows you to hear connecting tones: fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other party’s machine.
“ON” (default): You will hear connecting tones.
“OFF”: Deactivates this feature.
LIf the ring back tone continues, the other party’s machine may not be a fax machine or may have run out of paper. Check with the other party.
LThe connecting tone volume cannot be adjusted.
Code #79: Setting toner save feature
TONER SAVE
MODE=OFF [±]
“ON”: The toner cartridge will last longer.
“OFF” (default): Deactivates this feature.
Note:
LThis feature may lower the print quality by reducing toner consumption.
Code #80: Resetting advanced features to their default settings
SET DEFAULT
RESET=NO [±]
To reset the advanced features:
1.Press {MENU}.
2.Press {#}, then {8}{0}.
3.Press {A} or {B} repeatedly to select “YES”.
4.Press {SET}.
5.Press {SET} again.
6.Press {MENU}.
51
