Setup
TAD/FAX mode!
(receiving phone calls and faxes automatically)
When TAD/FAX mode is set, the unit will work as a fax machine and/or answering device.
If a fax tone is detected, the unit will automatically receive the fax. If a phone call is detected, the answering device will play a greeting message and the caller can leave a voice message.
Setting up the voice and fax message reception
1 | Make sure that feature #77 is set to |
“TAD/FAX” (p. 87). |
2 If the arrow (▼) is not shown on the right of the display, turn it on by pressing
AUTO ANSWER .
●The unit will play the
●The display will show the ring setting in TAD/FAX mode.
|
|
|
|
|
| Display: | PICKUP &RCV CALL | ||
|
|
|
|
|
| AFTER 2 | RINGS[±] | ||
|
|
|
|
|
|
|
| ||
3 | If you wish to change the ring setting, press | ||||||||
|
|
|
| or |
| until the desired setting (see | |||
|
|
|
|
| |||||
| below) is displayed, and press | SET . | |||||||
●You can change the speaker volume after
setting the ring setting. Press 
or 
while listening to the greeting message.
●The remaining time for recording incoming messages will be displayed.
Example: | _TIME_=_10m13s |
| |
|
|
AUTO ANSWER | SET |
Note:
●If the arrow (▼) is already shown on the right of the display and you wish to change the ring count, turn it off once then on again by pressing AUTO ANSWER and follow the instructions in step 3.
●The incoming message recording time can be changed (feature #10 on page 81).
●When the remaining time is low, erase unnecessary messages (p. 66). For voice memory capacity for incoming messages, see page 108.
●While an incoming call is being recorded, you can monitor it through the speaker. If this feature is not required, set feature #67 to off (p. 87).
Ring setting in TAD/FAX mode
You can choose from 1, 2, 3, 4, TOLL SAVER and RINGER OFF.
TOLL SAVER: When you call the unit from a remote location, the number of rings will tell you if there are any new voice messages. If the unit answers on the second ring, there is at least one new recorded message. If the unit answers on the fourth ring, there are no new recorded messages. To save the toll charges for the call, hang up immediately when you hear the third ring. The third ring indicates that there are no new recorded messages.
RINGER OFF: The unit will answer without ringing.
●If you subscribe to a Caller ID service, set to 2 or more rings.
●This setting can also be changed by feature #06 on page 80.
62
