Panasonic KX-PS8000 manual Connecting the Scanner to a Computer, peripheral devices are turned off

Setup

Connecting the Scanner to a Computer

Note for Terminator setting:

BThe terminator must be installed or set to ON on the last SCSI device only.

1	Make sure the computer, scanner and the other connected
	peripheral devices are turned off.
2	Connect the SCSI cable to the computer’s SCSI connector and to
	the scanner’s SCSI connector A or B.

BThe SCSI-2 board must be installed in the computer.

If you do not have a SCSI-2 board or a SCSI interface cable, you will need to purchase one from your local computer store or dealer ( ☞ P. 16, 157 “SCSI Interface” specifications).

BIf other SCSI devices are connected to the computer, connect the scanner anywhere in the SCSI chain.

Computer’s

SCSI connector

3 Make sure the SCSI ID No. of the scanner is 2 (default setting).

BIf other devices are connected to the computer, make sure that each SCSI device has a different ID No.

BTo change the scanner’s ID No., use the ID No. switches (#1, #2, #3) located on the back of the scanner. Also refer to Table 1 on page 52.

1 2 3 4

ON

47