Panasonic KX-PS8000 manual Connect the power cords to the scanner’s AC inlet, to

Setup

4 Make sure the SCSI ID No. of the scanner is 2 and that of the

printer is 1. (They are the default settings.)

BIf you have other devices connected to the computer, make sure that each SCSI device has a different ID No.

BTo change an ID No., use ID No. switches (#1, #2, #3) located on the back of the units. Also refer to Table 1 on page 52.

1 2 3 4

ON

ON

1 2 3 4

ScannerPrinter

5	Make sure the terminator switch (#4) of the scanner is set to OFF
	and that of the printer is set to ON. (They are the default settings.)
	BIf you have other devices connected to the computer, make sure the
	terminator switches of all those devices are set to OFF.
	BTo change the terminator setting, use the terminator switch (#4) located on
	the back of the units.
6	Connect the power cords to the scanner’s AC inlet, to the
	printer’s AC inlet and to AC outlets.

45