Panasonic KX-PS8000 manual Connecting the Printer to a Computer, Using a Scsi cable

Setup

Connecting the Printer to a Computer

Note for Terminator setting:

BThe printer must be the last device in the chain. The terminator setting of all other devices in the chain must be off.

■Using a SCSI cable:

1	Make sure the computer, printer and the other connected
	peripheral devices are turned off.
2	Connect the SCSI cable to the computer’s SCSI connector and
	the printer’s SCSI connector.
	BA SCSI-2 board must be installed in the computer.

If you do not have a SCSI-2 board or a SCSI interface cable, you will need to purchase one from your local computer store or dealer ( ☞ P. 16, 157 “SCSI Interface” specifications).

Computer’s

SCSI connector

3 Make sure the SCSI ID No. of the printer is 1 (default setting).

BIf you have other devices connected to the computer, make sure that each SCSI device has different ID No.

BTo change the printer’s ID No., use the ID No. switches (#1, #2, #3) located on the back of the printer. Also refer to Table 1 on page 52.

ON

1 2

3 4

49