Panasonic KX-TG1840AL operating instructions Intercom, Increasing the range of the base unit

TG1840AL(e-e).book Page 60 Tuesday, April 11, 2006 11:02 AM

Multi-unit Operation

4Enter “335”.

5Select “Cancel Base”, then press

{>}.

6Enter “0000” (default handset PIN).

L If you changed the PIN, enter it (page 32).

7Select the base unit(s) you want to cancel, by pressing the desired base unit number.

L The selected base unit number(s) will flash.

L To cancel a selected base unit number, press the number again. The number will stop flashing.

8Press {j/OK}.

9Select “Yes”, then press {>}.

10Press {ih}.

Note:

L To register the handset to another base unit or to the same base unit again, see manual registration (page 58).

Increasing the range of the base unit

You can increase the range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 6. Consult your Panasonic dealer for details.

Important:

L Before registering the repeater to this base unit, you must turn the repeater mode on.

Turning the repeater mode on/off

1Press {j/OK}.

2Select “Base Unit Setup”, then press {>}.

3Enter “0000” (default base unit PIN). L If you changed the PIN, enter it (page

38).

4Select “Other Options”, then press

{>}.

5Select “Repeater Mode”, then press

{>}.

6Select “On” or “Off”, then press {>}.

7Press {ih}.

Note:

L After turning repeater mode on or off, certain icons displayed on the base unit will disappear for a moment and w will flash on the handset momentarily. This is normal. The handset can be used once w stops flashing.

L While the repeater mode is turned on, audible call announcements may not be heard from the handset speaker.

Intercom

Intercom calls can be made between handsets/base unit in the same radio cell.

Between a handset and the base unit

When a handset calls the base unit

1Handset:

Press {INT} and {0}.

L The base unit will ring.

2Base unit:

Press {s} to answer.

3Handset:

When finished talking, press {ih}.

Base unit:

When finished talking, press {s}.

When the base unit calls a handset

1Base unit:

Press {x} and the desired handset number.

L The handset will ring.

60