Panasonic KX-TG1840AL Troubleshooting, Initial settings, Problem Cause & solution

TG1840AL(e-e).book Page 67 Tuesday, April 11, 2006 11:02 AM

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Initial settings

Problem	Cause & solution
w is flashing.	L The handset is not registered to the base unit.
	Register it (page 58).
	L The handset is too far from the base unit. Move
	closer.
	L The AC adaptor is not connected. Check the
	connections.
	L You are using the handset or base unit in an area
	with high electrical interference. Locate the handset
	and base unit away from interference sources, such
	as antenna and mobile phones.
The handset display is blank.	L The handset is not turned on. Turn the power on
	(page 16).
The handset will not turn on.	L Make sure that the batteries are installed correctly
	(page 14).
	L Fully charge the batteries (page 14).
	L Clean the charge contact and charge again (page
	14).

67