2Select “Handset Setup”, then press
{>}.
3Select “Registration”, then press {>} 2 times.
4Select a base unit number, then press
{>}.
L This number is used by the handset as a reference only.
5Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.
L After pressing {x}, the rest of this procedure must be completed within 1 minute.
6Wait until “Enter Base PIN” is displayed, then enter “0000” (default base unit PIN), then press {j/OK}.
L If you changed the PIN, enter it (page 38).
L When the handset has been registered successfully, w will stop flashing. If keytones are turned on (page 33), a confirmation tone will be heard.
Selecting a base unit
When “Auto” is selected, the handset will automatically use any available base unit it is registered to. When a specific base unit is selected, the handset will make and receive calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.
1Press {j/OK}.
2Select “Handset Setup”, then press
{>}.
3Select “Select Base”, then press
{>}.
4Select the desired base unit number, or “Auto”, then press {>}.
L The handset starts searching for the base unit.
Cancelling a handset
A maximum of 6 handsets can be registered to a base unit. A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This will allow the base unit to “forget” the handset.
1Press {j/OK}.
2Select “Base Unit Setup”, then press {>}.
3Enter “0000” (default base unit PIN). L If you changed the PIN, enter it (page
38).
4Enter “335”.
5Select “Cancel Handset”, then press
{>}.
L The numbers of all handsets registered to the base unit are displayed.
6Select the handset(s) you want to cancel, by pressing the desired handset number.
L The selected handset number(s) will flash.
L To cancel a selected handset number, press the number again. The number will stop flashing.
7Press {j/OK}.
8Select “Yes”, then press {>}.
9Press {ih}.
Cancelling a base unit
A handset can be registered to a maximum of 4 base units. A handset can cancel a base unit that it is registered to. This allows the handset to “forget” the base unit.
1Press {j/OK}.
2Select “Handset Setup”, then press
{>}.
3Select “Registration”, then press
{>}.
59
