Handset Settings
several seconds if the caller hangs up before you answer. You may hear a dial tone or no one on the line when you answer a call.
L The preset melodies in this product are used with permission of © 2004
Night mode
Night mode allows you to select a block of time during which the handset will not ring for outside calls. This feature is useful for times when you do not want to be disturbed, for example, while sleeping. Night mode can be set independently for the handset and the base unit (page 35).
Using the handset phonebook’s category feature (page 22), you can also select categories of callers whose calls will override night mode and ring the handset (Caller ID subscribers only).
Set the date and time beforehand (page 16).
Note:
L To avoid disturbances, we recommend turning the call screening feature off (page
56)in addition to turning the night mode feature on.
Setting the start and end time for night mode
1Press {j/OK}.
2Select “Handset Setup”, then press
{>}.
3Select “Ringer Setup”, then press
{>}.
4Select “Night Mode”, then press {>}.
5Select “Start/End”, then press {>}.
6Enter the desired hour and minute you wish to start this feature by selecting 2 digits for each.
L If you use
7Enter the desired hour and minute you wish to end this feature by selecting 2 digits for each.
L If you use
8Press {j/OK}.
9Press {ih}.
Turning night mode on/off
1Press {j/OK}.
2Select “Handset Setup”, then press
{>}.
3Select “Ringer Setup”, then press
{>}.
4Select “Night Mode”, then press {>}.
5Select “On/Off”, then press {>}.
6Select “On” or “Off”, then press {>}.
7Press {ih}.
Note:
L When the night mode is turned on, “[N]” is displayed.
Setting the ring delay for night mode
This setting allows the handset to ring during night mode if the caller waits long enough. After the selected amount of time passes, the handset will ring. If you select “No Ringing”, the handset will not ring during night mode.
1Press {j/OK}.
2Select “Handset Setup”, then press
{>}.
3Select “Ringer Setup”, then press
{>}.
4Select “Night Mode”, then press {>}.
5Select “Ring Delay”, then press {>}.
30
