Voice Mail Service

Setting the Voice Mail (VM) Tone Detection

(Cordless\Handset)

Your telephone company sends special signals (Voice mail tones) to activate the VM indicator.

Press or (DIGITAL\SP-PHONE)to listen to the dial tone. If you hear a series of dial tones followed by a continuous dial tone, this is indication that a new message was recorded.

Your phone comes set to detect these tones (set to “On”). Minutes after you hang up or after the phone stops ringing, your unit will seize the phone line and check if a message has been recorded. If a new message

was recorded at your telephone company, “Voice mail” and “ will” be displayed and the base unit VM (Voice mail) indicator will flash.

Set this programming to “Off” when:

you do not subscribe to a voice mail service,

your telephone company does not send a series of tones, followed by a continuous tone, or

your phone is connected to a business or office telephone system (PBX). Please refer to below to set this programming to OFF.

If you are not sure which setting is required, consult your local telephone company or contact Panasonic Customer Call Center.

Make sure the base unit and cordless handset are not being used.

1

Press (MUTE/FUNCTION), scroll to

Program” by pressing (›) or (‹), and

 

press (fl) (Yes key).

2

Scroll to “VM tone detect” by pressing

(›) or (‹).

3

Press (fl) (Yes key).

The current setting is displayed.

4

Select “On” or “Off” by pressing (›) or (‹).

5

Press (fl) (Save key).

A beep sounds.

To exit the programming mode, press (OFF).

LCD contrast

1Program

431=Yes

Save VM access#

1VM tone detect

431=Yes

VM tone detect :On

431=Save

VM tone detect :Off

431=Save

VM tone detect :Off

You can exit the programming mode any time by pressing (OFF).

54

Page 54
Image 54
Panasonic KX-TG2564S Setting the Voice Mail VM Tone Detection, Voice Mail Service, Press MUTE/FUNCTION, scroll to