CAUTION

When using the projector

Do not use the projector in places which are subject to humidity, dust, oil fumes or steam. Fire or electric shocks could result.

Do not place any heavy objects on top of the projector.

Doing so can cause the projector to become unbalanced and fall, which could result in damage and/or injury.

Do not look into the lens while the projector is being used.

Strong light is emitted from the projector’s lens. If you look directly into this light, it can hurt and damage your eyes.

Do not bring your hands or other objects close to the air outlet port.

Heated air comes out of the air outlet port. Do not bring your hands or face, or objects which cannot withstand heat close to this port, otherwise burns or deformation could result.

When disconnecting the power cable, hold the plug, not the cable.

If the power cable itself is pulled, the cable will become damaged, resulting in the possibility of fire or serious electric shocks.

Be sure to disconnect all cables before moving the projector.

If the projector is moved while some of the cables are still connected, the cables may become damaged, and fire or electrical shocks could result.

Cleaning and maintenance

Take particular care when replacing the lamp unit.

The metal halide lamp contains gas under high pressure. If it is dropped or hit against other objects, it may break, which could cause injury or problems with operation.

Ask an Authorized Service Center to clean inside the projector at least once a year.

If dust is left to build up inside the projector without being cleaned out, it can cause fire or problems with operation to occur. Ask your nearest Authorized Service Center to clean the projector when required. Consult your Authorized Service Center for details regarding cleaning costs.

Disconnect the power plug from the wall outlet as a safety precaution before carrying out any cleaning.

Electric shocks can result if this is not done.

Warning when using 220-240 V power supplies

When using this projector with a 220-240 V power supply, you must replace the power cord and the fuse. Use a power cord and fuse which corresponds to the specifications given at right. If this is not done, fire or malfunctions may result.

Replace the fuse by the following procedure.

Power cord

250 V AC, 10 A

Fuse

250 V AC, T4 A,

5.2 mm dia., 20 mm length

 

Insert a flat-tipped screwdriver with a narrow head into the hole below the fuse holder, and turn the screwdriver 2 - 3 times to the left and right.

After the fuse holder has moved forward slightly, pull it out toward you.

MAIN POWER

Replace the fuse with a 250 V AC, T4 A fuse, and then push the fuse holder securely back into place.

MAIN POWER

OFFO NOFFON

 

Fuse

AC IN

AC IN

4

Page 5
Image 5
Panasonic PT-L795U When using the projector, Cleaning and maintenance, Take particular care when replacing the lamp unit