Turning the power on and off
If the MAIN POWER switch on the projector is pressed while the cooling fan is still operating, the operating life Of the projector lamp will be shortened. Be sure to follow the procedures given below when turning the projector power supply on and off.
<Projector> | Power indicator |
POWER button
MAIN POWER switch
Turning on the power
1.Press the MAIN POWER switch.
Projector
2.Press the POWER button.
Projector Remote control unit
Press the MAIN POWER switch on the projector to the ON position.
The power indicator will illuminate red and the projector will switch to standby mode.
Press the POWER button on either the top of the projector or on the remote control unit.
The power indicator will alternate between green and orange.
The power indicator will illuminate green and a picture will be projected onto the screen after about 20 seconds.
Turning off the power
1.Press the POWER button. Projector Remote control unit
Press the POWER button on either the top of the projector or on the remote control unit.
The power indicator will illuminate orange and the projector will switch to standby mode.
2.Wait for the cooling fan to stop.
3.Press the MAIN POWER switch. Projector
Wait for a while (approximately 90 seconds) until the cooling fan stops operating. (When the fan stops, the power indicator will illuminate red.)
Press the MAIN POWER switch on the projector to the OFF position.
The power indicator will switch off and the power supply will be turned off.
NOTE:
If the power is turned off using the POWER button, the cooling fan will continue to operate (for approximately 90 seconds) while the inside of the projector is still at a high temperature. Do not turn the MAIN POWER switch to the OFF position, disconnect the power cord plug from the wall socket or shut off the mains power supply until the cooling fan stops operating.
If not using the projector for long periods of time, turn the MAIN POWER switch at the front of the projector to the OFF position.
If the POWER switch is accidentally turned off while the projector is being used, wait a while for the lamp to cool down before turning the power back on again. If you turn the power back on immediately, it will shorten the operating life of the lamp.
The REMOTE POWER function may cause the operation of the POWER button on the remote control unit to be disabled temporarily. For details about this function, refer to page 34.
If the MAIN POWER switch has not been turned off, the projector will still draw approximately 7 W (at
There may be cases where the lamp does not turn on straight away. In such cases, the projector will try to turn the lamp on again after 30 seconds have passed. (During this time, the power indicator will alternately flash green and orange.)-
The projector is equipped with a lens retracting function which will cause the lens to be retracted automatically when the power is turned off. However, the lens will not then return to the previously adjusted position even if the power is turned back on again. If you do not wish this function to operate, turn the function setting off while referring to “Using the lens retracting function” on page 36.
A tinkling sound may be heard while the power indicator is turned off, but this is not a sign of a malfunction.
When the power supply is turned on, the word “Panasonic” will be displayed on the screen. After
13
