Panasonic PT-L795U manual Back, bottom and right view, Side terminal board

<Back, bottom and right view>

Lamp unit cover (page 47)
Remove this cover to get access
to the lamp unit.	Front
Fixing screw for the lamp
unit cover (page 47)
Remove this screw when
replacing the lamp unit.
Adjuster button (page 17)
This button is used to
unlock the adjustable legs.
Adjustable legs (two) (page 17)
These legs can be used to adjust
the angle of inclination of the
projector.
<Side terminal board>

AUDIO OUT terminal (pages 38 and 39)

This terminal is used to output the audio signals from the source which is connected to the AUDIO IN terminals for RGB or video signals.

The signal which is output corresponds to the source which has been selected by pressing either the VIDEO or RGB button. The output level for this signal can be adjusted by using the VOL +/-buttons.

If audio equipment is connected to this terminal, no sound will be output from the built-in speakers.

RGB OUT connector (page 39)

This connector is used to output the RGB signals from the source which is connected to the RGB 1 or RGB 2 connector.

The signal which is output corresponds to the source which has been selected by pressing the RGB button.

RGB 2 (RGB IN/AUDIO IN) connector/terminal

(page 39)

This connector and terminal are used to input RGB signals and the audio signal which accompany them.

RGB 1 (RGB IN/AUDIO IN) connector /terminal (page 39)

This connector and terminal are used to input RGB signals and the audio signal which accompany them.

Remote control signal receptor (page 10)

This receives the infrared signal transmissions from the remote control unit.

Fixed legs

Air filter

S-VIDEO IN terminal (page 38)

This terminal is used to input S-VIDEO signals.

VIDEO IN terminal (page 38)

This terminal is used to input composite video signals.

AUDIO IN (L-R) terminals for S- VIDEO/VIDEO input (page 38) These terminals are used to input audio signals which correspond to the signals input to the VIDEO IN or S-VIDEO IN terminal.

SERIAL connector (page 41) This connector is used to con- nect a personal computer to the projector in order to exter- nally control the projector.

MOUSE connector (pages 39 and 40)

This connector is used to connect an accessory or separate mouse cable. This lets you operate a personal computer using the pointer button and click buttons on the remote control unit instead of using -- mouse.

8