Quickick Guideide
Loading the Alkaline Batteries
[ Bottom View ]
Lock Button
Slide all the way to the end.
Note
•When loading or unloading Batteries, be sure to slide the Battery Compartment lid all the way to the end before opening. If the lid is not slid to the end, Battery Loading and Unloading may be impossible.
1 While pressing the Lock Button, slide the Battery Compartment lid in the direction of the arrow and swing it open.
2 Install four Alkaline Batteries.
•Be sure to use Alkaline Batteries. Never use manganese batteries.
•Make sure that the positive (+) and
correct direction.
•Instead of the supplied Alkaline
batteries, you can also use AA type
3 Swing the Battery Compartment lid down and slide it shut.
G G e e t t t t i i n n g g
St t a a r r t t e e d d
WARNING! Do not dispose of Battery in fire, put in backwards, disassemble, or short circuit; otherwise it may leak or burst, causing possible personal injury.
Inserting the Memory Card*
*Memory Card : MultiMediaCard or SD Memory Card
•The captured images will be stored on this Memory Card.
•Be sure to insert the Memory Card before using the camera.
2 Slide the DOOR OPEN Switch to open the cover.
Insert the Memory Card, upper surface side up, into the card slot as shown by arrow.
3 Push the card fully into Memory Card Slot.
1 Set POWER Switch to OFF before inserting the Memory card.
7
3000.P | 7 | 00/09/25, 10:36 |
