Panasonic WJ-HD100 operating instructions Connections with PS Data Equipment

■Connections with PS • Data Equipment

Camera

Camera In

POWER

ON

OFF

Camera Out

Video In

POWER

ON

OFF

If the cable is locally procured, make sure it is data grade cable suitable for RS-485 communication. A 2- wire twisted pair shielded cable, BELDEN 9406 or equivalent should be used. Pin assignments and data flow are shown below.

	No.	Name	Data Flow		No.	Controller
1	1	GND		–	1
						end
	2	RX(B)	WJ-HD100 ←	WV-CU360	2
						1
	3	RX(A)	WJ-HD100 ←	WV-CU360	3
	4	TX(B)	WJ-HD100 →	WV-CU360	4
	5	TX(A)	WJ-HD100 →	WV-CU360	5
6						6
	6	GND		–	6

Data Multiplex Unit

Video Monitor

ALARM

ALARM SUSPEND

Data Multiplex Unit WJ-MP204

DATA Port

Video Multiplexer

POWER

ON

OFF

Note:

Set the field rate to

7.5fps or slower when connecting the Camera SW Out signal with the video multiplexer.

CAM SW		Rec
In		Out
		Play
		In
IN		IN
OUT		OUT
AUDIO	CAMERA	VIDEO MONITOR OUT	RS-232CDATA
	SW OUT
		(PLAY)

DATA Port		Multi Screen			Video In
		Out
DATA Port			Digital Disk Recorder WJ-HD100
(EXT REC) JOG-CLICK JOG-LEFT JOG-RIGHT	G ALARM SEARCH STEP	REW/FF STOP/SETUP PLAY REC G OUT IN PLAY OUT	REC OUT AUTO OFF OUT DISK END OUT OUT IN	G RECALL OUT RECOVER OUT RESET IN	POWER
					ON
					SIGNAL GND
					IN
					OFF
MODE	REMOTE	TIME	SERIES	ALARM
		ADJUST	RECORD

Camera SW	Video In Monitor Out
Out
	DATA Port
	System Controller

		Set the termination to
ON		ON for the units at both
		ends of the chain, and to
		OFF for units in the
	MODE
		middle.

System Controller with PS•Data

Capability

PS• Data equipment must be set up for communication as follows:

•Protocol selection: PS • DATA

•Unit Address: Set an address unique in the chain.

•Baud rate, data bit length, parity check, stop bit: Choose the same settings as used for the other equipment in the chain.

Recommended video multiplexers are Panasonic’s WJ-FS series or similar models having specifications as follows.

•Switching recognition signal is located within 8H prior to the end of vertical blanking.

•A camera switching rate of 4/60 seconds or more is available.

11