■COMMUNICATION SETUP
Communication parameters are set to match those of the connected devices and the system configuration.
COMMUNICATION SETUP
PROTOCOL | PS•DATA |
UNIT ADDRESS | 1 |
BAUD RATE | 9600 |
DATA BIT | 8 |
PARITY CHECK | NONE |
STOP BIT | 1 |
WAIT TIME | OFF |
PROTOCOL | PS•DATA |
UNIT ADDRESS | 1 |
BAUD RATE | 9600 |
DATA BIT | 8 |
| DISPLAY SELECT |
| LCD CONTRAST |
1.Move the cursor to UNIT ADDRESS with the [▲] or [▼] button.
2.Select the address with the JogDial. The default value is 1.
From 1 to 96: Set an address unique in the chain.
●Protocol
501 PROTOCOL
PROTOCOL | PS.DATA |
UNIT ADDRESS | 1 |
BAUD RATE | 9600 |
DATA BIT | 8 |
PARITY CHECK | NONE |
| DISPLAY SELECT |
| LCD CONTRAST |
1.Move the cursor to PROTOCOL with the [▲] or [▼] but- ton.
2.Select a suitable protocol with the JogDial. The default is PS • DATA.
PS • DATA: Select when the communication chain uses the PS • DATA protocol. This selection enables the DATA terminal on the rear panel for communication.
VCR: Select when other than PS • DATA is used.
This selection enables the
Note: Parallel use of the DATA and
●Unit Address
502 UNIT ADDRESS
The unit address can be set either from the setup menu on the monitor or using the DIP switch on the rear panel. The address setup with the DIP switch has priority over the setup on the monitor menu. Make certain to set DIP switch- es #1 through #4 to OFF before setting the unit address on the monitor.
●Baud Rate
503 BAUD RATE
UNIT ADDRESS | 1 |
BAUD RATE | 9600 |
DATA BIT | 8 |
PARITY CHECK | NONE |
| DISPLAY SELECT |
| LCD CONTRAST |
1.Move the cursor to BAUD RATE with the [▲] or [▼] but- ton.
2.Select the rate with the JogDial.
The default value is 9 600 bits per second.
4800: 4 800 bps
9600: 9 600 bps
19200: 19 200 bps
●Data Bit
504 DATA BIT
BAUD RATE | 9600 |
DATA BIT | 8 |
PARITY CHECK | NONE |
STOP BIT | 1 |
| DISPLAY SELECT |
| LCD CONTRAST |
1. Move the cursor to DATA BIT with the [▲] or [▼] button.
30
