2.Rotate the JogDial to select ON or OFF.
ON: Buzzer beeps while alarm is active.
OFF: Buzzer does not beep.
●Motion Detector Setup 306 VMD SETUP
A VMD or Video Motion Detector senses changes in the video signals within a preset area and supplies alarm out- put. When a change is detected, the recorder starts recording. The detection sensitivity and area are selected on this menu.
| ALARM SETUP | ||
REC MODE | SF- 12H | ||
REC | RATE | 15FPS | |
REC | QUALITY | ||
DURATION | 10S | ||
ALARM | BUZZER | ON | |
VMD SETUP | OFF |
| |
1.Move the cursor to VMD SETUP with the up [▲] or down [▼] button.
2.Rotate the JogDial to select the desired parameter, then press the JogDial. The default is OFF.
[LOW 
]: Low sensitivity motion detection is enabled.
[MID 
]: Medium sensitivity motion detection is enabled.
[HIGH 
]: High sensitivity motion detection is enabled.
[OFF]: Motion detection is disabled.
The area setup window appears with an asterisk when other than OFF is selected. The asterisk represents the
Notes:
•VMD should be used with an ordinary camera input to the unit. Select [OFF] to avoid useless VMD when a video multiplexer or combination camera supplies the input to the unit.
•Make sure that the date and status displays are not located within the motion detection area on the monitor. Otherwise the motion detector could be misled.
•Set the ALARM SUSPEND to ON with the LCD button when VMD is unnecessarily activated during the VMD setup.
•VMD does not function while playing back.
3.Set the
REW/FF |
|
/ |
|
STEP |
|
/ |
|
PUSH • PAUSE | SET |
/ | / |
4.Press the JogDial to enter the
5.Set the
6.Press the JogDial. The area is highlighted.
Up to 4 areas can be selected. These may partially overlap. Repeat steps 3 to 6 to select more areas. To unselect an area, move the cursor to the
q | e |
w |
r |
28
