Precautions

This product has no power switch.

Power is supplied from an external 12 V DC/ 24 V AC (WV-CL934) or 120 V AC (WV- CL930) power-supply device. Refer to serv- ice personnel for how to turn on/off the power.

To keep on using with stable performance

Parts of this product may deteriorate and it may shorten lifetime of this product when using in locations subject to high temperatures and high humidity. Do not expose this product to direct heat sources such as a heater.

Use the product at temperature within –10°C to +50°C {14°F to 122°F} and humidity below 90 %. (When using this product without turning the power off)

Do not rub the edges of metal parts with your hand.

Failure to observe this may cause injury.

Do not attempt to disassemble this prod- uct.

To prevent electric shock, do not remove screws or covers.

There are no user-serviceable parts inside. Ask qualified service personnel for servicing.

Use this product for indoor use only.

Do not expose this product to direct sunlight for hours and do not install the product near a heater or an air conditioner. Otherwise, it may cause deformation, discoloration and malfunction. Keep this product away from water.

Handle this product with care.

Do not abuse this product. Avoid striking, shaking, etc. The product could be damaged by improper handling or storage.

Cleaning this product body

Turn the power off when cleaning this prod- uct. Use a dry cloth to clean this product. Do not use strong abrasive detergent when cleaning this product. When the dirt is hard to remove, use a mild detergent and wipe gently. Then, wipe off the remaining deter- gent with a dry cloth.

Otherwise, it may cause discoloration. When using a chemical cloth for cleaning, read the caution provided with the chemical cloth product.

Noise on monitor

This product is equipped with a super sensi- tive CCD. Therefore, white dot noise may appear on the monitor. This phenomenon is not trouble.

Discoloration on the CCD color filter

When continuously shooting a bright light source such as a spotlight, the color filter of the CCD may have deteriorated and it may cause discoloration. Even when changing the fixed shooting direction after continuously shooting a spotlight for a certain period, the discoloration may remain.

Do not aim this product at strong light sources.

A light source such as a spot light causes a blooming (light bleeding) or a smear (vertical lines).

Smear

Bright subject

Blooming

7

Page 7
Image 7
Panasonic WV-CL930, WV-CL934 operating instructions Precautions