Patton electronic 6511RC user manual Installing the network cables

Model 6511RC User Manual 2 • Hardware installation

6.Insert the front blade into the front chassis slot corresponding to the slot in which you installed the rear blade. Verify that the release buttons in the handles click up to indicate that the board is fully seated and locked into place.

Installing the network cables

This section describes installing network interface cables on the following front and rear Matrix Switch blade ports:

•The Matrix Switch front blade’s 10/100 Ethernet LAN port and an EIA 561 RS-232 CONFIG port (see figure 13).

•The Matrix Switch rear blade’s STM-1 SDH WAN port (presented in SC optical and 75-ohm BNC electri- cal formats) and two 10/100/100 Ethernet WAN/LAN management ports (see figure 14)

Figure 13. Matrix Switch front blade network interface ports

Figure 14. Matrix Switch rear blade network interface ports

Installing the network cables 35