Model 6511RC User Manual

5 • Troubleshooting and maintenance

 

 

Table 6. LED status indications and recommended actions (Continued)

LED

Location

Color

Status

Meaning

 

 

 

 

 

CLK ERROR

Front

Yellow

On solid

Primary Reference clocking source has been lost and the 6511RC is

 

panel

 

 

using the Secondary Reference as its clocking source. Matrix Switch

 

 

 

 

operation should continue unimpaired.

 

 

 

 

Visit the System Clocking Overview page and examine the current

 

 

 

 

clocking configuration and status.

 

 

 

 

Use the clocking configuration and status information to determine

 

 

 

 

the appropriate course of action to restore the Primary Reference

 

 

 

 

clock source to operation.

 

 

 

 

 

 

 

 

Flashing

Master Clock source and the Secondary Clock source have been lost

 

 

 

 

and the 6511RC is using its internal crystal for its clock. Matrix Switch

 

 

 

 

operation should continue unimpaired.

 

 

 

 

Visit the System Clocking Overview page to examine the current

 

 

 

 

clocking configuration and status.

 

 

 

 

Use the information in determined the appropriate course of action to

 

 

 

 

restore the Primary Reference to operation.

 

 

 

Off

No clock errors currently detected. No action recommended.

TEST MODE

Front

Green

On solid

The STM-1 port is currently operating in some test mode.

 

panel

 

 

No action recommended.

 

 

 

Off

None of the G.SHDSL ports is operating in test mode.

 

 

 

 

No action recommended.

WANa

Front

Green

On solid

Indicates the STM-1 port is activated, synched, and operating normally.

 

Panel

 

 

No action recommended.

 

 

 

Single

Indicates that the Model 6511RC is detecting the SDH network, but is

 

 

 

Flash

unable to synchronize with it.

 

 

 

 

Verify the STM-1 cables are fully and correctly connected.

 

 

 

 

Examine the SDH Configuration page and ensure each parameter

 

 

 

 

value matches the corresponding value in the connected SDH net-

 

 

 

 

work.

 

 

 

Off

Indicates rear module not present or STM-1 port is not configured.

 

 

 

 

Ensure rear module is incorrectly installed; install if absent.

 

 

 

 

Examine the SDH Configuration page and ensure each parameter

 

 

 

 

value matches the corresponding value in the connected SDH net-

 

 

 

 

work.

ENET

Front

Green

Flashing

Indicates there is Ethernet frame activity on at least one of the eight PICMG

(SWITCH)

Panel

 

or

2.16 connections to other blades on the PSB bus.No action recommended.

 

 

 

On solid

 

 

 

 

Off

Indicates no Ethernet frame activity detected on the PICMG 2.16 bus.

 

 

 

 

No action recommended.

 

 

 

 

 

ENET(REAR)

Front

Green

Flashing

Indicates Ethernet frame activity on one or both of the 10/100/1000

 

Panel

 

or

Ethernet ports. No action recommended

 

 

 

On solid

 

 

 

 

 

 

General fault analysis

85

Page 85
Image 85
Patton electronic 6511RC user manual Enet