05/08 Rev. AB | OPERATOR’S HANDBOOK | Setup |
| |
| 9844/9854 |
| ||
|
|
|
|
Loading Fan-fold Material
Follow these steps to load
1.Open the cover.
2.Release the printhead pressure lever (1).
3.Position the
4.Guide the material over the material unwinder. Push the material guide up to the edge of the material without pinching the material.
5.Slide the light barrier fitting using the grip
(6) until the pointer (7) is located above the material perforations (Fig. 2).
The optional reflex sensor is located 5mm to the right of the pointer below the material!
6.Thermodirect printing: Close the pressure
lever. Thermotransfer printing: See “Loading Ribbon” to continue.
1
2
