05/08 Rev. AB | OPERATOR’S HANDBOOK | Getting Started |
| ||||
|
| 9844/9854 |
|
| |||
|
|
|
|
|
| ||
| Operating Modes |
|
|
|
| ||
Offline Mode |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| Display |
| Meaning |
|
|
|
|
| OFFLINE | 0 JOBS | No jobs are waiting to be processed. |
|
|
|
|
|
|
|
|
|
|
|
|
Tab. 1:Display in offline mode.
Settings can be made when the printer is offline. The offline mode is normally active when the printer is turned on. Print jobs are received with the selected interface, but not processed.
To configure the printer so it goes online when turned on, set the following parameter to Online:
SYSTEM PARAMETER >
Online Mode | In online mode, print jobs are received and processed immediately. | |||
|
|
|
|
|
| Display |
|
| Meaning |
| ONLINE | 0 JOBS | No jobs are waiting to be processed. | |
|
|
|
|
|
| ONLINE | 0. | JOBS | Current data transfer to the printer is shown on |
|
|
|
| the display by the dot on the bottom right, next to |
|
|
|
| the number of loaded jobs. |
| ONLINE | 13 | JOBS | During printing, the display also shows the |
| Restcount: 25 |
| number of print jobs read (13) and the remaining | |
|
|
|
| number of labels (25) to be printed in the current |
|
|
|
| job. |
|
|
|
|
|
| ONLINE | 13 | JOBS | If a print job recognizes an endless (continuous) |
| Restcount: endless | number of labels to be printed, then the remaining | ||
|
|
|
| number for this job is also shown as endless. |
|
|
|
|
|
Tab. 2: Possible messages in online mode.
To stop printing, press Online.
Message Mode The printer uses the message mode to signal an error or a particular operating status. Message mode indicates that the printer is waiting to quit or for a fault to be corrected. When exiting, the printer switches from message mode to offline mode (depending on the error and the progress of the previous process).
Display |
| Meaning |
Status | 5001 | Messages are made up of the status number and |
No punch detected | a brief descriptive text. | |
|
|
|
Tab. 3: Example of a message.
The messages shown in Table 3 occur when the printer is set for using labelling material with perforation, but continuous form material without perforation is loaded. The printer continues to feed the material for a few seconds before it generates an error message.
PRefer to the “Error Messages” section on your
