05/08 Rev. AB | OPERATOR’S HANDBOOK | Care & Maintenance |
| |
| 9844/9854 |
| ||
|
|
|
| |
|
|
|
|
|
Cleaning the Punch (Die Cut) Sensor
During printing, the punch sensor can become contaminated with lint and unable to sense material.
1.Remove the cover (1) gently and swivel downwards (Fig. 1).
2.Remove the sensor arm (2) (Fig. 2).
3.Clean the opening (3) with compressed air.
1
The transmission sensor is located in the upper and the lower part of the sensor arm on a level with the indicator (4). You can find the reflex sensor about 5 mm further below.
CAUTION! - The sensor surface is very sensitive to scratches!
Do not use sharp objects or solvents when cleaning the sensors.
2
