Selecting Ribbon/Material, About Material | Paxar 9854, 9844

05/08 Rev. AB	OPERATOR’S HANDBOOK	Setup		2-5
	9844/9854			2-5
	9844/9854

Selecting Ribbon/Material

About Material

Use Monarch-approved material. See “Specifications” for more information.

About Ribbons

Use Monarch-approved ribbon. See “Specifications” for more information.

Image 33

Paxar 9854, 9844 manual Selecting Ribbon/Material, About Material, About Ribbons

Contents

Operators Handbook Copyright Safety Information Service General safety notes Equipment safety Battery Disposal Information Disposal Procedures Canadian D.O.C. Warning FCC Regulations Class B Table of Contents Getting Started Installing the Printer Unpacking the printerCarrying the Printer Removing the Transportation Lock Printer Contents Terms to Know Exterior view of the printer About the Printer Takeup Peel and Liner About the 9854 Dispenser Peel and Internal Liner Takeup Dispenser Mode with Dispensing Edge Sensor Identifying Printer Connections Start/stop signal input Serial Interface Safety Information Using the Control Panel Display Offline Mode Online ModeOperating Modes Standalone ModeOnly Connecting the Printer Using the Printer Using the 9854 Printer with Internal Liner Takeup Setting the InterfaceDisable Enable Parameter Possible Settings Using the 9854 Printer with Dispenser Offline Operation ConfiguringPosition Label length Print Info Online Operation Sending a Print Job Creating a Print jobWindows Printer Driver Compact Flash Using Compact Flash CardsCard Inserting a CF card Outputting the realtime clock value using Easy Plug Setting the Realtime Clock 9854 only Setup Material and ribbon path in printer Loading Diagrams Printer with Internal Liner Takeup Reel Rewinder Material and ribbon path through printer with dispenser peel Printer with Dispenser Peel Selecting Ribbon/Material About MaterialAbout Ribbons Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Replacing a used ribbon Loading a Ribbon Quick ribbon exchange Material/Ribbon End Material Stock EndRibbon End Adjusting wheel for the printhead support Setting Printhead Support Parameter Setting the Material Parameters OPERATOR’S Handbook Care & Maintenance Safety Care & MaintenanceTroubleshooting Calling Technical Support Frequency of Care Cleaning the Printhead Cleaning with the cleaning pen order part numberCleaning with isopropyl alcohol Connecting the printhead Replacing the PrintheadRemoving the printhead ™ š Cleaning the Print Roller Cleaning the Punch Die Cut Sensor Specifications Printers Specifications Ribbon Foil Supplies Material Specifications Page Toll Free