05/08 Rev. AB

 

OPERATOR’S HANDBOOK

Getting Started

 

1-3

 

 

9844/9854

 

 

 

 

 

 

 

 

 

 

Printer Contents

 

 

 

 

 

After you unpack your printer, make sure you have all the necessary

 

 

 

 

components and that the printer was not damaged during shipping.

 

 

 

Printer

 

 

 

 

Power supply cable

 

 

 

 

 

The plug for the power supply is different depending on the country of

 

 

 

 

delivery.

 

 

 

 

Data cable

 

 

 

 

 

Centronics IEEE 1284 CA Cable 2 m.

 

 

 

 

Core adapters

 

 

 

 

 

There are two core adapters each for the material rolls with a internal core

 

 

 

 

diameter of 3 inches (76mm) and 4 inches (101 mm). The core adapters are

 

 

 

 

placed on the printer material dispenser.

 

 

 

 

Empty foil core

 

 

 

 

 

For rewinding the ribbon (foil). The backing paper is placed on foil rewind

 

 

 

 

reel.

 

 

 

 

Operator’s Handbook

 

 

 

 

Size 10 Torx screwdriver

 

 

 

 

 

Used to replace the print roller and add a dispensing (peel) edge.

 

 

9854 with

9854 printer with installed deflector

 

 

 

Internal Liner

Housing front part, bottom side with screw (Fig. 3 right side)

 

 

 

Takeup Reel

 

Use the housing parts if the printer does not have the internal liner takeup

 

 

 

 

reel (rewinder).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Fig. 3: These housing parts are shipped loose with the printer with internal liner takeup.

 

Removing the Transportation Lock

1.

Open the cover.

2.

Remove the two foam pads holding the printhead in place.

9854 with

Remove the connector from its transport position at the printer bottom and

Dispenser

connect it to the front of the printer.

Page 11
Image 11
Paxar 9854, 9844 manual Printer Contents, Removing the Transportation Lock