05/08 Rev. AB | OPERATOR’S HANDBOOK | Setup | |
|
|
|
9844/9854
Dispensing (Peel) 9854 only
1.Follow the steps for loading material from the previous section. Then, follow these steps.
2.Remove the labels from the first 10 inches (25 mm) of backing paper (Fig. 1).
3.Press the red button (1) at the dispensing edge to release the peel roller (Fig. 1).
4.Remove the peel roller, feed the label web through as illustrated (Fig. 1) and press the roller back between its bearings.
5.Thread the backing paper backwards to the takeup reel (2) as shown (fig. 2).
6.Wrap the end of the backing paper clockwise around the takeup reel (2) and secure it with the clip (3).
7.Turn the takeup reel
After turning on the printer, the reel rotates slowly until the material web is pulled tight (Fig. 3).
You may see
Status5004 Rewinder mat. tear
before the material is pulled tight.
If this happens, press Online to clear the message. You may need to press it several times.
1
2 | |
|
3