Pelco C1977M-D manual Connecting To The LAN Port, Connecting Power

Step 3: Connecting To The LAN Port

1

Key:

2

3

1= Ethernet (10BASE-T) LAN connection to hubs, network, PCs (RJ-45 connector)

2 = Ethernet Cat5 cable

3 = Transmitter or receiver

Figure 4. Connecting To The LAN Port

To connect to the Ethernet network, use a standard UTP Cat5 cable with RJ-45 connectors. Plug this cable into the RJ-45 receptacle labeled “Ethernet/UTP” at the rear of the unit. The connection to a 10BASE-T network can be made directly via a hub or switch.

Step 4: Connecting Power

1	2	4
		3

Key:

1= Ethernet (10BASE-T) LAN connection to hubs, network, PCs (RJ-45 connector)

2 = Ethernet Cat5 cable

3 = Transmitter or receiver

4 = AC plug power adapter

Figure 5. Connecting Power

Attach the power adapter. Plug the primary side into the wall outlet and the secondary side with the small clip into the unit.

The green power LED on the front is lit constantly when the power adapter is connected correctly.

The green LINK LED next to the RJ-45 connector indicates a correct connection to the Ethernet network.

Pelco Manual C1977M-D (6/02) [ 13 ]