Pelco C1977M-D manual Configuration Default Settings Description

The following table gives detailed information about the items on the General Settings Configuration Page, together with the default factory settings:

	Table B. General Settings
Configuration	Default
Item	Settings	Description
Name	none	The unit name helps the user identify a particular
		unit, especially if many PelcoNet Transmission Sys-
		tems are on the network.
ID	none	The ID serves as a machine-readable name. The ID
		can be read at any time. Reading is facilitated re-
		motely via UDP/IP, letting a management system
		monitor the unit.
Password level	none	This field lets you set the password at either the
		user or service level.
Password	none	The unit can be password-protected to prevent unau-
		thorized tampering with the configuration. The pass-
		word needs to be repeated correctly in the confirm box
		before password protection is activated. Once pass-
		word protection is enabled, you need to log in before
		the configuration pages can be accessed (Figure 27).
IP address	192.168.0.1	Enter a unique IP address that is valid for your network.
	(192.168.0.2 for	The pre-configured default IP address allows for easy
	receiver)	configuration in closed environments. You can use a
		crossed cable to directly connect to a PC. Also, the
		PC’s IP address and subnet mask must match the
		default IP address.
		NOTE: Changing the IP address also affects the
		current browser connection. You will have to enter
		the new URL to regain connectivity to the unit.
Subnet mask	255.255.255.0	Exchange with a valid subnet mask for your network,
		if subnets are in use.
Gateway IP	none	The IP address of the router. Typically used in a
		WAN environment.
Base Port	25000	This setting lets the user designate which TCP/IP
		ports PelcoNet uses for transmission, video, audio,
		and control. For example, the default setting of
		25000 means PelcoNet will use TCP ports 25000-
		25001 and UDP ports 25002-25011 (12 ports total)
		for all video and control data.
Mail server	none	Only required if the mail-sending feature is to be
IP address		used. Outgoing e-mail is sent to the mail server
		(SMTP server) at the given IP address.
		(Continued on next page)

[ 34 ] Pelco Manual C1977M-D (6/02)