Pelco C1977M-D manual Test Between Audio-Equipped Transmitter and PC, DX3000 Warning Reset Button

Test Between Audio-Equipped Transmitter and PC

1.Connect a microphone (via a preamplifier) to the Line-In cinch plug or connect a handset to the RJ-11 plug on the unit.

2.Make sure the correct menu items are set in the Audio Configuration Page—that is, select the appro- priate interface (line in/out or handset).

3.Switch the coding mode to G.711 or G.728.

4.Select a volume above zero.

5.Connect a loudspeaker to the PC’s soundcard. After establishing the Ethernet connection, audio should be transmitted both ways.

6.Be sure not to set the level too low. Ensure the right interface is selected.

7.If you cannot hear any audio, check the microphone and loudspeaker together with other equipment. Make sure the microphone is switched on if it has a power switch.

DX3000 Warning Reset Button

PelcoNet displays a warning message if there is a problem with the DX3000 DVR. Click this green button to reset the unit. The codes are defined as follows:

Code Definition

00None

01Hard drive full

02Hard drive near end

03No signal

04Copy or backup or restore—check media

05Copy or backup or restore—size error

06Archive full

07Archive near end

08Copy or backup—overtake error

09Copy or backup—near overtake

10Recording or copy or backup or restore or system—system error

11Copy or backup or restore—read/write error

Pelco Manual C1977M-D (6/02) [ 65 ]