Pelco C2953M-B manual Turning On Dhcp, Turning Off Dhcp

Models: C2953M-B

1 66
Download 66 pages 2.2 Kb
Page 27
Image 27
TURNING ON DHCP

TURNING ON DHCP

The default Dynamic Host Configuration Protocol (DHCP) setting for the camera is DHCP On. If the DHCP option is set to Off, complete the following steps to reset it to On.

1.Place your mouse pointer over the Network tab.

2.Select General from the drop-down menu.

3.Select the On option for DHCP.

4.Click the Save button to save the settings, or click the Reset button to clear all of the information you entered without saving it.

NOTE: If the camera is not connected to a DHCP server but DHCP is set to On, the default IP address 192.168.0.20 on subnet mask 255.255.255.0 is automatically assigned to the camera. After the first camera is connected and assigned the default IP address, the system will automatically look for other cameras on the auto IP address system and assign IP addresses in sequential order as required. For example if three cameras are connected to a network without a DHCP server, the first camera will be assigned address 192.168.0.20, the second camera will be assigned address 192.168.0.21, and the third camera will be assigned address 192.168.0.22.

TURNING OFF DHCP

TURNING OFF DHCP WARNING: Contact your network administrator to avoid any network conflicts before setting or changing the IP address of the device.

1.Place your mouse pointer over the Network tab.

2.Select General from the drop-down menu.

3.Select the Off option for the Dynamic Host Configuration Protocol (DHCP).

4.Change the following network settings as required:

IP Address: The address of the camera connected to the network.

Subnet Mask: The address that determines the IP network that the camera is connected to (relative to its address).

Gateway: The router that accesses other networks.

DNS Servers: The addresses of the dedicated servers that translate the names for Web sites and hostnames into numeric IP addresses.

5.Click the Save button to save the settings, or click the Reset button to clear all of the information you entered without saving it.

C2953M-B (10/09)

27

Page 27
Image 27
Pelco C2953M-B manual Turning On Dhcp, Turning Off Dhcp