Pelco DX3016-120, DX3016-060, DX3009-060 manual Dvd-Ram, Hdd, Iomega Z250S

5.Optional. Connect peripheral recording devices.

By connecting peripheral recording devices to the recorder through the SCSI interface (SCSI-II half-pitch 50-pin), storage space can be increased and archiving and copying functions can be performed.

To increase storage space, up to two (DX3009-060, DX3016-060, and DX3016-120) or three (DX3009-030) peripheral hard disk drives (maximum of 34 GB per unit for DX3009 models or 103 GB per unit for DX3016 models) can be added to supplement the built-in hard disk.

For archiving or copying functions, a tape or disk device can be connected. The following tape devices can be connected to the recorder:

Pelco	DX3000-D25 (drive)
Pelco	DX3000-T25 (blank tape)

The following disk devices can be connected to the recorder:

MO (640 MB)	Fujitsu SMB-640WF
MO (1.3 GB)	Fujitsu SMB-1300W
DVD-RAM	Panasonic LF-D200JD
HDD	SCSI-IF Type
Zip (250 MB)	IOMEGA Z250S

Connections between the recorder and peripheral devices are made with SCSI cables (not supplied). As SCSI cables differ with each device, check for the appropriate pin arrangement before use. Cables must not exceed 3 feet (1 m).

On the rear panel of the recorder is a SCSI termination switch. Set the switch ON when nothing is connected the SCSI connector. Set to OFF when connecting periph- eral devices.

Correct termination is necessary to maintain proper electrical connections to the pe- ripheral devices. Make sure that the last peripheral device is terminated. (Depending on the device, the terminator may be built into the device. In this case, set the built-in terminator correctly.) Use an active terminator for SCSI.

Set the SCSI ID number of the peripheral recording device. Refer to the operation manual of each peripheral recording device for setting the SCSI ID Number. Use ID1-3 for hard drives, ID4 for an archive device, and ID5 for a copy device. On DX3016 mod- els, also use ID4 when a hard disk drive is connected for repeated backup recording (considered an archiving function).

AUDIO MIC

IN

OUT

				CAMERA IN					VIDEO
1	2	3	4	5	6	7	8	9	OUT
				CAMERA OUT					Y/C
1	2	3	4	5	6	7	8	9

RS-232C

1 2 3 4 5 6 7 8 9

GND

CLOCKADJ

REC

POWERON

POWEROFF

ALARMOUT

MODEOUT

OUTCALL

OUTCALLGND

GND

GND

5VDCOUT

30mAMAX

GND

GND

ON

OFF

ALARM IN

SCSI

RESET

TERMINATION

SCSI

AUDIO MIC

IN

OUT

				CAMERA IN					VIDEO
1	2	3	4	5	6	7	8	9	OUT
				CAMERA OUT					Y/C
1	2	3	4	5	6	7	8	9

RS-232C

1 2 3 4 5 6 7 8 9

GND

CLOCKADJ

REC

POWERON

POWEROFF

ALARMOUT

MODEOUT

OUTCALL

OUTCALLGND

GND

GND

5VDCOUT

30mAMAX

GND

GND

ON

OFF

ALARM IN

SCSI

RESET

TERMINATION

SCSI

			Peripheral
Terminator		SCSI	hard disk
SCSI			SCSI cable drives
	Peripheral	terminal
terminal	copy/archive
SCSI cable	device		Terminator
	01147

SCSI cable

011487

Figure 12. Connecting Peripheral Recording Devices (DX3009 Models Shown)

Pelco Manual C681M-D (2/02) 15