Philips BL-C10 operating instructions Setting Description

		Operating Instructions
	Setting	Description
Allow Access from		• Allow Access from the Internet setting automatically
the Internet		configures the router's Port Forwarding setting (some
(Automatic Setup		routers call it "Address Translation", "Static IP
Only)		Masquerade", "Virtual Server" or "Port Mapping"). To
		enable Internet access to the camera, check [Yes]. In this
		case, the camera automatically searches the unused port
		number on your network in the order of 80 and from 50000
		to 50050. To disable Internet access to the camera, check
		[No].
Network		• If you prohibit the Setup Program from changing the
Configuration from		network settings, clear the check box.
Setup Program
(Static/DHCP Only)
Port Number		• You can set the camera port number (80 by default). When
(Static/DHCP Only)		you use multiple cameras with a router on your network,
		each camera must be assigned its own port number (see
		page 12 "1.5 Connecting the Camera to a Router Not
		Supporting UPnP™" in the Installation/Troubleshooting).
		• Do not set the following port numbers.
		E.g., FTP: 20 and 21, Telnet: 23, SMTP: 25, DNS: 53,
		POP3: 110, HTTPS:443, ICQ: 4000 and IRC: 6661—6667.
		• Enter only the number (1—65535).
		• Some ISPs do not allow you to use port 80. Ask your ISP
		or network administrator about the accessible port number
		over the Internet.
•	IP address	• If your ISP or network administrator specifies the IP
•	Subnet Mask	address and subnet mask, enter them in each data field.
(Static Only)		• If you use the camera on the LAN, set the IP address in the
		same class as your PC (see page 94).
		• Set 4 digits (0—255) and 3 periods such as
		"192.168.0.253". But "0.0.0.0" and "255.255.255.255" are
		not available.
Host Name		• If your ISP uses the DHCP function which automatically
(DHCP Only)		assigns the IP address to the camera, enter the ISP-
		assigned host name. (Host name may be used as an
		authentication.)
		• Enter ASCII characters for the host name (see page 102).
		But [Space], ["], ['], [&], [<] and [>] are not available.

31