Pioneer DEH-3100UB operation manual Initial Settings, Switching the auxiliary setting

Black plate (26,1)

Section

04Initial Settings

2Press MULTI-CONTROL to display the setting mode.

3Turn MULTI-CONTROL to select the AM tuning step.

Turning MULTI-CONTROL will switch the AM tuning step between 9 kHz and 10 kHz. The se- lected AM tuning step will appear in the dis-

play.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

4Press MULTI-CONTROL to determine

the selection.

# Even if the menu has been cancelled before determination, operation is settled.

Switching the auxiliary setting

It is possible to use auxiliary device with this unit. Activate the auxiliary setting when using auxiliary device connected to this unit.

1Use MULTI-CONTROL to select AUX in the initial setting menu.

Refer to Adjusting initial settings on the pre- vious page.

2Press MULTI-CONTROL to turn AUX on.

# To turn AUX off, press MULTI-CONTROL again.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker lead out- put and RCA rear output) can be used for full- range speaker (REAR SP :FULL/

PREOUT:REAR) or subwoofer

(REAR SP :SUB W/PREOUT:SUB W) connec- tion. If you switch the rear output setting to REAR SP :SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp.

Initially, the unit is set for rear full-range speak- er connection (REAR SP :FULL). When rear

26 En

output is connected to full range speakers (when REAR SP :FULL is selected), you can connect the RCA subwoofer output to a sub- woofer. In this case, you can select whether to use the subwoofer controller’s (low pass filter, phase) built-in PREOUT:SUB W or the auxili- ary PREOUT:REAR.

1 Use MULTI-CONTROL to select

SW CONTROL in the initial setting menu. Refer to Adjusting initial settings on the pre- vious page.

2Press MULTI-CONTROL to display the

setting mode.

# Press DISP/BACK/SCRL to return to the pre- vious display.

3Use MULTI-CONTROL to select the de- sired setting.

Press to switch the segment you wish to set between left and right. Turn to change the set- ting of each segment.

Left segment	Right segment
REAR SP	FULL (full-range speaker)
(rear speaker setting)	SUB W (subwoofer)
PREOUT	SUB W (subwoofer)
(RCA output setting)	REAR (full-range speaker)

#When you select REAR SP :SUB W, you can not set PREOUT (RCA output setting).

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 23).

!If you change this setting, subwoofer output in the audio menu will return to the factory settings.

!Both rear speaker lead outputs and RCA rear

output are switched simultaneously in this setting.

<YRD5269-A/S>26